Tehran University of Medical Sciences

Science Communicator Platform

Stay connected! Follow us on X network (Twitter):
Share this content! On (X network) By
Influence of Primers and Additional Resin Layer on Zirconia Repair Bond Strength Publisher Pubmed



Shafiei F1 ; Fattah Z1 ; Kiomarsi N2 ; Dashti MH3
Authors
Show Affiliations
Authors Affiliations
  1. 1. Oral and Dental Disease Research Center, Department of Operative Dentistry, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran
  2. 2. Department of Operative Dentistry, Tehran University of Medical Sciences, Dental Faculty, International Campus, Tehran, Iran
  3. 3. Department of Restorative Sciences and Biomaterials, Postdoctoral Prosthetics, Henry M. Goldman School of Dental Medicine, Boston, MA, United States

Source: Journal of Prosthodontics Published:2019


Abstract

Purpose: To evaluate the influence of alloy/zirconia primer and 10-methacryloyloxydecyl dihydrogen phosphate (MDP)-containing resin layer treatments on the shear bond strength (SBS) of composite resin to zirconia after aging. Materials and Methods: Sixty zirconia (Y-TZP) blocks were air-abraded (35-µm Al2O3) and divided into 6 experimental groups (n = 10) in terms of primer/resin layer as follows: (1) control, without any primer or resin; (2) AP, Alloy Primer; (3) ZPP, Z-Prime Plus; (4) PL/ZPP, Z-Prime Plus with light polymerization; (5) AP+SEB, Alloy Primer along with light-cured bonding resin of a self-etch adhesive system (SE Bond); and (6) ZPP+SEB, Z-Prime Plus with SE Bond. After composite resin placement and light polymerization, the specimens were stored in distilled water (37°C for 4 months) and thermal-cycled for 6000 cycles. The SBS was tested with a universal testing machine. Statistical analysis of the SBS data was performed with one-way ANOVA, followed by HSD Tukey test (α = 0.05). Results: There were significant differences between the groups (p < 0.001, F = 116.5). All the groups revealed significantly higher SBS than the control (p < 0.001). ZPP+SEB group exhibited the highest SBS (16.14 ± 2.52 MPa) and AP group the lowest SBS (7.00 ± 1.97 MPa) among experimental groups; both had significant differences with the other groups (p < 0.001). There were no significant differences between ZPP, PL/ZPP, and AP+SEB groups (p > 0.05). Conclusions: The bond strength between zirconia ceramic and composite resin was affected by different primers/resin layer. Applying an MDP-containing resin layer along with both primers resulted in significant enhancement of SBS. This improvement for Z-Prime Plus was significantly higher than that of Alloy Primer. © 2018 by the American College of Prosthodontists
Experts (# of related papers)
Other Related Docs
13. Hybrid Implant Abutments: A Literature Review, European Journal of General Dentistry (2021)