Isfahan University of Medical Sciences

Science Communicator Platform

Stay connected! Follow us on X network (Twitter):
Share this content! On (X network) By
Defluoridation of Water Using Activated Alumina in Presence of Natural Organic Matter Via Response Surface Methodology Publisher Pubmed



Samarghandi MR1 ; Khiadani M2, 3 ; Foroughi M1 ; Zolghadr Nasab H1
Authors
Show Affiliations
Authors Affiliations
  1. 1. Department of Environmental Health Engineering, School of Health, Hamadan University of Medical Sciences, Hamadan, Iran
  2. 2. School of Engineering, Edith Cowan University, Joondalup, 6027, WA, Australia
  3. 3. Environment Research Centre, Isfahan University of Medical Sciences, Isfahan, Iran

Source: Environmental Science and Pollution Research Published:2016


Abstract

Adsorption by activated alumina is considered to be one of the most practiced methods for defluoridation of freshwater. This study was conducted, therefore, to investigate the effect of natural organic matters (NOMs) on the removal of fluoride by activated alumina using response surface methodology. To the authors’ knowledge, this has not been previously investigated. Physico-chemical characterization of the alumina was determined by scanning electron microscope (SEM), Brunauer–Emmett–Teller (BET), Fourier transform infrared spectroscopy (FTIR), X-ray fluorescence (XRF), and X-ray diffractometer (XRD). Response surface methodology (RSM) was applied to evaluate the effect of single and combined parameters on the independent variables such as the initial concentration of fluoride, NOMs, and pH on the process. The results revealed that while presence of NOM and increase of pH enhance fluoride adsorption on the activated alumina, initial concentration of fluoride has an adverse effect on the efficiency. The experimental data were analyzed and found to be accurately and reliably fitted to a second-order polynomial model. Under optimum removal condition (fluoride concentration 20 mg/L, NOM concentration 20 mg/L, and pH 7) with a desirability value of 0.93 and fluoride removal efficiency of 80.6 %, no significant difference was noticed with the previously reported sequence of the co-exiting ion affinity to activated alumina for fluoride removal. Moreover, aluminum residual was found to be below the recommended value by the guideline for drinking water. Also, the increase of fluoride adsorption on the activated alumina, as NOM concentrations increase, could be due to the complexation between fluoride and adsorbed NOM. [Figure not available: see fulltext.] © 2015, Springer-Verlag Berlin Heidelberg.
Other Related Docs
17. Performance Evaluation of Fenton Process Removing Fluoride From Aqueous Solution, International Journal of Environmental Health Engineering (2015)
19. Removal of Acid Red 14 by Pumice Stone As a Low Cost Adsorbent: Kinetic and Equilibrium Study, Iranian Journal of Chemistry and Chemical Engineering (2012)