Tehran University of Medical Sciences

Science Communicator Platform

Stay connected! Follow us on X network (Twitter):
Share this content! On (X network) By
Dental Implants’ Stability Dependence on Rotational Speed and Feed-Rate of Drilling: In-Vivo and Ex-Vivo Investigations Publisher Pubmed



Mirzaie T1 ; Rouhi G1 ; Mehdi Dehghan M2, 3 ; Farzadmohajeri S2, 3 ; Barikani H4
Authors
Show Affiliations
Authors Affiliations
  1. 1. Faculty of Biomedical Engineering, Amirkabir University of Technology, Tehran, Iran
  2. 2. Department of Surgery and Radiology, Faculty of Veterinary Medicine, University of Tehran, Tehran, Iran
  3. 3. Institute of Biomedical Research, Faculty of Veterinary Medicine, University of Tehran, Tehran, Iran
  4. 4. Dental Implant Research Center, Tehran University of Medical Sciences, Tehran, Iran

Source: Journal of Biomechanics Published:2021


Abstract

This study aimed to explore the effects of drilling rotational speed and feed-rate on the stability of dental implants through in-vivo and ex-vivo experiments. To this end, a total of 16 identical dental implants were inserted in the mandible of four dogs. The osteotomies were made with two drilling rotational speeds, i.e., 800 and 1500 rpm, and two different feed-rates, i.e., 1 and 2 mm/s. Implant stability quotients (ISQs) were recorded immediately after inserting implants and then each week for four subsequent weeks. Then, all animals were euthanized, and a bone sample containing the implants was extracted from each hemi-mandible for the pull-out test. A two-way ANOVA was performed for ISQs, and pull-out strengths (PoS), and the significance level was set to <0.05. The effect of rotational speed and feed-rate, used in this study, on the primary stability quotients was not significant (P > 0.05). Increasing the rotational speed from 800 to 1500 rpm significantly increased both ISQ and PoS values at the end of the 4th week after the implantation (P = 0.022 and P = 0.001, respectively). Moreover, by decreasing the feed-rate from 2 to 1 mm/s, a significant increase in PoSs of the dental implants was observed four weeks after the implantation (P = 0.019). Results of this study showed that either by increasing drilling rotational speed, here from 800 to 1500 rpm, or by reducing feed-rate, here from 2 to 1 mm/s, the secondary stability would be reinforced. Further investigations are needed to see if and how the conclusions made in this study can be generalized. © 2021