Tehran University of Medical Sciences

Science Communicator Platform

Stay connected! Follow us on X network (Twitter):
Share this content! On (X network) By
Shear Bond Strength of Colored and Sandblasted Zirconia to Ceramic Veneers Fabricated by the Pressing and Layering Techniques: An in Vitro Study Publisher



Abbasi M1 ; Ebadian B2 ; Aminianpour N3, 4
Authors
Show Affiliations
Authors Affiliations
  1. 1. Department of Prosthodontics, School of Dentistry, Shahrekord University of Medical Sciences, Shahrekord, Iran
  2. 2. Department of Prosthodontics, Dental Implants Research Center, Dental Research Institute, School of Dentistry, Isfahan University of Medical Sciences, Isfahan, Iran
  3. 3. Dental Research Center, Dentistry Research Institute and Department of Prosthodontics, School of Dentistry, Tehran University of Medical Sciences, Tehran, Iran
  4. 4. Student Research Committee, Shahrekord University of Medical Sciences, Shahrekord, Iran

Source: International Journal of Dentistry Published:2023


Abstract

Introduction. Porcelain-veneered zirconia (PVZ) restorations are increasingly used due to their optimal esthetics and high strength. However, chipping of porcelain limits the application of PVZ restorations. The aim of this study was to assess the shear bond strength (SBS) of colored and sandblasted zirconia to ceramic veneers fabricated by the pressing and layering techniques. Materials and Methods. Sixty cubic zirconia specimens (10 × 10 × 2 mm) were assigned to three groups according to their surface treatment: (I) control, (II) sandblasting with 50 μm alumina particles (S), and (III) coloring (C). Each group was subsequently divided into two subgroups according to the porcelain-veneering technique: (I) layering (L) and (II) pressing (P). The specimens underwent 10,000 thermal cycles between 5 and 55°C, and their biaxial SBS was measured in an electromechanical universal test machine (0.5 mm/min with 2.5 kN load cell). The failure mode was also assessed under a stereomicroscope. Three samples were randomly selected from each subgroup (n = 18) for examination of zirconia-phase transformation by X-ray diffraction (XRD). Two-way and one-way ANOVA followed by the post hoc Tukey test were used to analyze statistical differences among the groups and subgroups (α = 0.05). Results. The sandblasted zirconia with press porcelain (SP) subgroup showed the highest (24.40 ± 8.16 MPa) and the colored zirconia with press porcelain (CP) subgroup showed the lowest (13.76 ±3.62 MPa) SBS. All failures were cohesive. Rate of phase transformation in layered porcelain was significantly lower than that in pressed porcelain (P<0.01). Conclusion. The sandblasted group showed the highest and the colored group showed the lowest SBS; the layered group showed higher SBS than the pressed group. © 2023 Mahsa Abbasi et al.
Related Docs
1. Effect of Hydroxyapatite Coating in Combination With Physical Modifications on Microshear Bond Strength of Zirconia to Resin Cement, International Journal of Dentistry (2023)
2. Retention and Clinical Performance of Zirconia Crowns: A Comprehensive Review, International Journal of Dentistry (2020)
3. Effect of Nonthermal Plasma on Shear Bond Strength of Translucent Zirconia in Layering Ceramic, International Journal of Dentistry (2023)
4. Comparative Evaluation of the Effect of Implant Crown Materials on Implant Components and Bone Stress Distribution: A 3D Finite Element Analysis, International Journal of Dentistry (2023)
Experts (# of related papers)
View all Related Experts
Faezeh Atri (3)
Hamid Jalali (1)