Evaluation of Microhardness of Two Bulk-Fill Composite Resins Compared to a Conventional Composite Resin on Surface and in Different Depths Publisher



Saati K¹ ; Khansari S² ; Mahdisiar F¹ ; Valizadeh S³ Show Affiliations
Source: Journal of Dentistry (Iran) Published:2022

Abstract

Statement of the Problem: One of the problems with light-cured composite resins is the limitation and inadequate depth of curing and polymerization, resulting in low surface mi-crohardness and restoration failure. Purpose: The present study aimed to compare the surface microhardness of two different bulk-fill composite resins and one conventional composite resin using the Vickers micro-hardness test. Materials and Method: In the present in vitro study, 108 samples from two different bulk-fill composite resins (Tetric N Ceram and Xtrafil) and one conventional composite resin (Filtek Z250) were prepared in metallic molds (2×4×10 mm) (n=36 for each composite resin). Six samples from each composite resin (n=6) underwent a hardness measurement test at specific depths (0.1, 1, 2, 3, 4 and 5mm). The samples were then stored at 37ºC for 24 hours, followed by a microhardness test at the depths mentioned above. Results: In all the composite resin samples, microhardness decreased with an increase in depth. The highest microhardness was recorded in Filtek Z250, followed by Xtrafil, with no significant difference. The lowest microhardness was recorded in Tetric N Ceram bulk-fill. Both bulk-fill composite resins at all the depths exhibited depth-to-surface standard micro-hardness (>80%). Conclusion: According to the results, both evaluated bulk-fill composite resins exhibited favorable surface microhardness up to a depth of 5 mm. © 2022, Shiraz University of Medical Sciences. All rights reserved.